Consists of a Structural and Mechanical Inspection.

The Structural part of the home inspection will cover the following areas:
1.    Foundation (interior and exterior structural)
2.    Roof Covering
3.    Roof Framing and Bracing
4.    Cross Ventilation
5.    Site Conditions
6.    Porches

The Mechanical part of the home inspection will cover the following areas:
1.    A/C & Heating Systems
        a.    Air Conditioning System Cooling Properly
        b.    Inspect visible supply lines
        c.    Safety Disconnects
        d.    Furnace Installation
        e.    Cross Contamination
        f.    Venting
        g.    Gas leak connections

2.    Plumbing Systems
        a.    System drainage at fixtures
        b.    Plumbing leaks and drips
        c.    Gas leaks at connections
        d.    Gas leaks at meter

3.    Water Heater
        a.    Proper Installation
        b.    Vent Pipe Installation
        c.    Test Temperature / Pressure Relief valve
        d.    Check recognized Hazards

4.    Electrical Systems
        a.    Operation of fixtures
        b.    Proper wire/breaker installation and ground fault interrupters (GFI)
        c.    Check for Aluminum wiring
        d.    Reverse polarity and open grounds
        e.    Grounding of vent hood, stove, ceiling fans, and applicable appliances
        f.    Bonding of Neutral bar
        g.    Conduit Installations
        h.    Appliance operation (ovens, disposal, dishwasher) not (washer, dryer, refrigerator)